Morphy Richards Vacuum Cleaner User Manual download pdf (Page 6)

6

6

UK Helpline 0870 060 2604

Replacement Parts 0870 167 663 Ireland Helpline 1800 409119

6

SAFETY CUT-OUT

If the cleaner overheats a motor

protection thermostat will

automatically switch the motor

off. If this happens, switch the

cleaner off, unplug from the

power supply and leave the

cleaner to cool for at least

60 minutes. Check the

airways for blockages, empty

dust canister and clean the

filters before restarting.

CLEANING THE

FILTERS

To maintain suction the

pleated filter must be

shaken clean each time the

dust canister is emptied.

Failure to clean the filter will

reduce suction and could

damage the motor if used for a

prolonged period. This may

invalidate the guarantee. If the

filters become damaged they

must be replaced.

Pleated filter

This must be shaken clean at

every emptying to maintain

suction. To thoroughly clean it

wash it regularly.

To remove it from the dust

canister lid turn the filter 1/4

turn anti-clockwise. G Wash in

warm water (no detergent) and

allow to air dry before refitting.

The spare pleated filter allows

one filter to be washed and

dried whilst the other is in use.

Motor protection filter

H

The motor protection filter Ò is

located underneath the dust

canister

1 Remove the dust canister.

2 Lift out the filter and shake over

a dustbin.

The filter may also be washed in

water (no detergents) but must

be totally dry before re-fitting.

3 Replace the filter

Exhaust filter

I

The exhaust filter is located

below the dust canister

compartment.

1 Remove the front cover.

2 Remove the exhaust filter Ú by

pulling forward at the top and

lift it away.

3 Take the filter out of the cage

and shake vigorously over a

dustbin. The filter may also be

washed in warm water. Do not

use detergents. The filter must

be completely dry before re-

fitting. Allow filters to air dry

naturally.

4 Replace the filter and front

cover.

Changing the belt

If the brush bar stops rotating it

is likely that the drive belt has

snapped (usually because the

brush has been stalled). A spare

belt is supplied. Replacement

belts can also be obtained from

Morphy Richards.

Accessing the floor

nozzle

I

1 Disconnect the cleaner from the

mains supply.

2 Put switch to off position.

3 Remove front cover and dust

canister.

4 Press the handle release pedal

and place the cleaner face

down, in a flat position on a soft

surface (eg carpet).

5 Using a flat bladed screwdriver

or a coin, rotate the three cover

fixings, a quarter of a turn, from

lock to unlock I .

6 Lift the base cover, from the rear

fixing area first, the cover will

rotate forward. Unhook cover

from front edge and remove M.

H

G

I

73360 rev4 11/7/06 14:43 Page 6

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments